home *** CD-ROM | disk | FTP | other *** search
/ Atari Mega Archive 1 / Atari Mega Archive - Volume 1.iso / misc / cap.arc / G4.DOC < prev    next >
Text File  |  1987-07-07  |  1KB  |  20 lines

  1.  
  2. 4.0 Selection of Output Quantities and Frequency Sweep
  3.     ==================================================
  4.  
  5. After a circuit has been input, but before calculation beings, you will need to
  6. select those quantities you wish to observe and the frequencies at which to ob-
  7. serve them. There are two ways that the program can provide output. printed
  8. table of up to 50 quantities per frequency, or a displayed plot.
  9. Only one method can be selected at a time.
  10.  
  11. Available output quantities are node voltages, branch voltages, branch currents
  12. branch power and ratio of any two quantities. Node voltage zero is not avail-
  13. able for output, but is always 0 volts at 0 degrees. A branch voltage is the
  14. voltage across an element. It is the node voltage at the positive node minus
  15. the node voltage at the negative node. The positive node for a controlled or
  16. independent current source, by convention, is the node where the current leaves
  17. the source (the TO node). The positive node for resistors, inductors and capa-
  18. citors again by convention, is the node where current enters the element ( the
  19. FROM node.
  20.